Jet Clone Damper Cam Adjustments (Limit Switch Adjustments)

New Types
  1. Remove M4 cap nut, then remove limit switch cover.
    (Note) When removing the limit switch cover, use extra caution in order to avoid damaging the signal lines.

  2. Loosen set screw with 2.5mm socket wrench and tilt damper shaft at 20 degrees to turn limit switch on.

  3. After adjusting, securely tighten set screw.

  4. Install limit switch cover and tighten cap nut.
    (Note) When removing the limit switch cover, use extra caution not to damage the signal line.
Old Type

[Condition]
If cam position is poor, convey problems will happen due to "no convey signal" or "no full capacity signal."
[Adjustment]
  1. Remove any material in contact with damper. Set in free condition.
  2. Loosen set screw with hex socket wrench. From position where damper hangs down naturally (cam slightly rotated to the left), adjust cam to make limit switch turn on at slightly open position. Then secure by tightening set screw.







Scroll to Top