SMGL Low-speed, Screen-less Grinder
	Issues > Check/Troubleshooting

		Granulator will not start, even if start button is pressed
		Clamps of feed hopper/cutter chamber are not secured Particles in the feed hopper/cutter chamber Limit Switch is not working properly

	1. Clamps of feed hopper/cutter chamber are not secured If clamps are loose, the CLOSE limit switch will not work, preventing operation Check to see if all clamps are tightly secured If any of the clamps are loose, tighten securely If problem persists Return to top of the page
	2. Dust/Particles in feed hopper/cutter chamber If there are any dusts or particles (i.e. metal parts), they will interfere with cutters and cause noise Always begin work after turning power off! Remove feed hopper clamps and slowly open hopper to side where hopper tips Check for dusts or particles. Remove if necessary If problem persists Return to top of the page
	3. Limit switch is not working properly If limit switch does not work properly, equipment will not start since closure of feed hopper cannot be confirmed Check to see if limit switch is pushed If equipment does not start even with the limit switch pushed, the switch is defective. Replace the limit switch Order for limit switch If problem persists Return to top of the page