MGD Portable Hot Air Dryer/Loader
	Issues > Check/Troubleshooting

		Blower is overloaded and overload relay trips. (i.e. CP-2 trips)
		Clog in cartridge filter (in conveying line filter case) and drying/regenerate filter. Weld damage/wear on contact point of electromagnetic switch in control panel. Weld damage/wear on contact point of electromagnetic switch in control panel.

	1. Clog in cartridge filter (in conveying line filter case) and drying/regenerate filter. If clogged, air will not circulate, potentially leading to overload to blower. Check to see if each filter is clogged. If dirty or clogged, blow clean dry air into filter and remove the clinging particles. [Point]   Wear a mask when cleaning. Dust/particles will disperse in the air when blowing dry air. blowing dry air. When the filter is badly clogged, replace with new filters. Drying Filter (Exhaust) Order by Phone/FAX If problem persists Return to top of the page
	2. Weld damage/wear on contact point of electromagnetic switch in control panel. Weld damage/wear on contact point of electromagnetic switch in control panel. Start work after stopping operation and check that breaker is off. Those who do not have sufficient mechanical/electrical knowledge should not do any maintenance work requiring disassembly or repairing due to risk of injuries and dangers of work. Check to find any weld damages and wear on contact points, as well as any abnormalities. [Point] After checking, securely set white cover back on. Reference: Tolerance - 2 million times. [Abnormal Function]   Condition where magnetic points are damage and center section is caved in during machine stops or does not caved in even when pressing by hand.   Start work after stopping operation and check that breaker is off. Those who do not have sufficient mechanical/electrical knowledge should not do any maintenance work requiring disassembly or repairing due to risk of injuries and dangers of work. Replace switch if weld damage or wear is found, or when function is abnormal. Electromagnetic Switch Replacement If problem persists Return to top of the page
	3. Set value for thermal device in control panel not set. Overload alarm will happen when set value is not correct. Start work only after stopping operation and turning breaker off! Check set value of electromagnetic switch at area where trip happened. Thermal Settings If problem persists Return to top of the page